Skip to content

1992 Audi S4 tire and wheel sizes, bolt pattern and tire pressure

Check the tables below for every tire size, wheel size, bolt pattern (PCD), rim offset and tire pressure fitted to the 1992 Audi S4.

1992 Audi S4 tire sizes

Bolt pattern
Fitment tables

2 trims sold in 1992

Open a trim for its factory package and every alternative size, front and rear.

Audi S4 C4

1991 – 1994 2 trims

S4 2.2 Turbo quattro

227 hp · 2.2L AAN I5 215/60 ZR15 93Z 6 fitments
GenerationC4 1991–1994
Power227 hp
Engine2.2L AAN I5, Petrol
Center bore57.1 mm
PCD5x112
ThreadM14 x 1.5
Tire sizeRim size and bolt patternPressure, psiPrices
215/60 ZR15 93Z15x7.5 ET40 5x11235TiresRims
195/65 R15 91T15x7 ET45 5x11235TiresRims
215/60 R15 93T15x7 ET45 5x11235TiresRims
215/60 R15 93T15x7.5 ET40 5x11235TiresRims
225/50 ZR16 93Z16x8 ET40 5x11235TiresRims
245/40 ZR17 93Z17x8 ET40 5x11236TiresRims

S4 4.2i quattro

276 hp · ABH V8 215/60 ZR15 93Z 6 fitments
GenerationC4 1991–1994
Power276 hp
EngineABH V8, Petrol
Center bore57.1 mm
PCD5x112
ThreadM14 x 1.5
Tire sizeRim size and bolt patternPressure, psiPrices
215/60 ZR15 93Z15x7.5 ET40 5x11235TiresRims
225/50 ZR16 93Z16x8 ET40 5x11235TiresRims
195/65 R15 91T15x7 ET45 5x11235TiresRims
215/60 R15 93T15x7 ET45 5x11235TiresRims
215/60 R15 93T15x7.5 ET40 5x11235TiresRims
245/40 ZR17 93Z17x8 ET40 5x11236TiresRims
Reading the table

What these columns mean

OE fitment
The package fitted at the factory for that trim.
Alternative
A size the car accepts without modification — plus-sizing, winter setups or optional wheels.
Rim size
Rim diameter × width in inches, and the factory offset (ET) in millimetres, e.g. 18x7.5 ET25.
Bolt pattern (PCD)
Number of studs and the diameter of the circle they sit on. It must match exactly.
Center bore
Diameter of the hub hole. Larger aftermarket bores need hub-centric rings.
Pressure
Recommended cold inflation pressure for that axle, in psi.
Staggered
A wider tire on the rear axle than the front. Front-to-back rotation is not possible.
Thread size
Lug bolt or nut thread — needed when buying aftermarket fasteners.

Considering a different size?

Run your OE size against the one you want to see diameter change, ground clearance and speedometer error.