1992 Holden Calibra tire and wheel sizes, bolt pattern and tire pressure

Check the tables below for every tire size, wheel size, bolt pattern (PCD), rim offset and tire pressure fitted to the 1992 Holden Calibra.

1992 Holden Calibra tire sizes

Bolt pattern

Other years

Fitment tables

Open a trim for its factory package and every alternative size, front and rear.

1991 – 1995 1 trim

114 hp · 2.0 L C20NE I4 Petrol 2.0 L C20NE I4 195/60 VR15 6 fitments

GenerationYE 1991–1995

MarketAustralia

Power114 hp

Engine2.0 L C20NE I4 Petrol 2.0 L C20NE I4, Petrol

Center bore56.6 mm

PCD4x100

ThreadM12 x 1.5

Fit	Tire size	Rim size and bolt pattern	Pressure, psi	Prices
OE	195/60 VR15	15x6 ET49 ~~4x100~~	33 F / 30 R	Tires Rims
Alt	175/70 R14	14x5.5 ET49 ~~4x100~~	33 F / 30 R	Tires Rims
Alt	195/60 VR14	14x5.5 ET49 ~~4x100~~	33 F / 30 R	Tires Rims
Alt	205/55 VR15	15x6 ET49 ~~4x100~~	33 F / 30 R	Tires Rims
Alt	205/50 VR16	16x6 ET49 ~~4x100~~	33 F / 30 R	Tires Rims
Alt	205/50 VR16	16x7 ET42 ~~4x100~~	33 F / 30 R	Tires Rims

Reading the table

OE fitment: The package fitted at the factory for that trim.
Alternative: A size the car accepts without modification — plus-sizing, winter setups or optional wheels.
Rim size: Rim diameter × width in inches, and the factory offset (ET) in millimetres, e.g. 18x7.5 ET25.
Bolt pattern (PCD): Number of studs and the diameter of the circle they sit on. It must match exactly.
Center bore: Diameter of the hub hole. Larger aftermarket bores need hub-centric rings.
Pressure: Recommended cold inflation pressure for that axle, in psi.
Staggered: A wider tire on the rear axle than the front. Front-to-back rotation is not possible.
Thread size: Lug bolt or nut thread — needed when buying aftermarket fasteners.