1990 Holden Statesman tire and wheel sizes, bolt pattern and tire pressure

Check the tables below for every tire size, wheel size, bolt pattern (PCD), rim offset and tire pressure fitted to the 1990 Holden Statesman.

1990 Holden Statesman tire sizes

205/65R15

Bolt pattern

Other years

Fitment tables

Open a trim for its factory package and every alternative size, front and rear.

1990 – 1994 1 trim

221 hp · 5.0 L LB9 V8 Petrol 5.0 L LB9 V8 205/65 R15 1 fitment

GenerationVQ 1990–1994

MarketAustralia

Power221 hp

Engine5.0 L LB9 V8 Petrol 5.0 L LB9 V8, Petrol

Center bore69.6 mm

PCD5x120

ThreadM12 x 1.5

Fit	Tire size	Rim size and bolt pattern	Pressure, psi	Prices
OE	205/65 R15	15x6 ET39 ~~5x120~~	–	Tires Rims

Reading the table

OE fitment: The package fitted at the factory for that trim.
Alternative: A size the car accepts without modification — plus-sizing, winter setups or optional wheels.
Rim size: Rim diameter × width in inches, and the factory offset (ET) in millimetres, e.g. 18x7.5 ET25.
Bolt pattern (PCD): Number of studs and the diameter of the circle they sit on. It must match exactly.
Center bore: Diameter of the hub hole. Larger aftermarket bores need hub-centric rings.
Pressure: Recommended cold inflation pressure for that axle, in psi.
Staggered: A wider tire on the rear axle than the front. Front-to-back rotation is not possible.
Thread size: Lug bolt or nut thread — needed when buying aftermarket fasteners.