Skip to content

2011 MG 3 tire and wheel sizes, bolt pattern and tire pressure

Check the tables below for every tire size, wheel size, bolt pattern (PCD), rim offset and tire pressure fitted to the 2011 MG 3.

Bolt pattern

2 generations were sold in 2011. Check your chassis code before ordering wheels.

Fitment tables

3 trims sold in 2011

Open a trim for its factory package and every alternative size, front and rear. More than one generation was on sale this year — check the chassis code against your VIN before ordering.

MG 3 II

2011 – 2013 2 trims

3 1.3i

91 hp · 1.3L 13S4C I4 185/70 R14 88H 4 fitments
GenerationII 2011–2013
Power91 hp
Engine1.3L 13S4C I4, Petrol
Center bore56.1 mm
PCD4x100
ThreadM12 x 1.5
Tire sizeRim size and bolt patternPressure, psiPrices
185/70 R14 88H14x5.5 ET45 4x10030TiresRims
185/65 R15 88H15x6 ET50 4x10030TiresRims
195/55 R16 87H16x6.5 ET50 4x10030TiresRims
205/50 R16 87V16x6.5 ET50 4x10030TiresRims

3 1.5i

107 hp · 1.5L 15S4C I4 185/65 R15 88H 4 fitments
GenerationII 2011–2013
Power107 hp
Engine1.5L 15S4C I4, Petrol
Center bore56.1 mm
PCD4x100
ThreadM12 x 1.5
Tire sizeRim size and bolt patternPressure, psiPrices
185/65 R15 88H15x6 ET50 4x10030TiresRims
195/55 R16 87H16x6.5 ET50 4x10030TiresRims
205/50 R16 87V16x6.5 ET50 4x10030TiresRims
205/45 R17 88V17x7 ET48 4x10033TiresRims
Reading the table

What these columns mean

OE fitment
The package fitted at the factory for that trim.
Alternative
A size the car accepts without modification — plus-sizing, winter setups or optional wheels.
Rim size
Rim diameter × width in inches, and the factory offset (ET) in millimetres, e.g. 18x7.5 ET25.
Bolt pattern (PCD)
Number of studs and the diameter of the circle they sit on. It must match exactly.
Center bore
Diameter of the hub hole. Larger aftermarket bores need hub-centric rings.
Pressure
Recommended cold inflation pressure for that axle, in psi.
Staggered
A wider tire on the rear axle than the front. Front-to-back rotation is not possible.
Thread size
Lug bolt or nut thread — needed when buying aftermarket fasteners.

Considering a different size?

Run your OE size against the one you want to see diameter change, ground clearance and speedometer error.