1982 Nissan March tire and wheel sizes, bolt pattern and tire pressure
Check the tables below for every tire size, wheel size, bolt pattern (PCD), rim offset and tire pressure fitted to the 1982 Nissan March.
1982 Nissan March tire sizes
Bolt pattern
Fitment tables
1 trim sold in 1982
Open a trim for its factory package and every alternative size, front and rear.
No trims match these filters
Try a trim name or an engine size like 2.0L.
Reading the table
What these columns mean
- OE fitment
- The package fitted at the factory for that trim.
- Alternative
- A size the car accepts without modification — plus-sizing, winter setups or optional wheels.
- Rim size
- Rim diameter × width in inches, and the factory offset (ET) in millimetres, e.g. 18x7.5 ET25.
- Bolt pattern (PCD)
- Number of studs and the diameter of the circle they sit on. It must match exactly.
- Center bore
- Diameter of the hub hole. Larger aftermarket bores need hub-centric rings.
- Pressure
- Recommended cold inflation pressure for that axle, in psi.
- Staggered
- A wider tire on the rear axle than the front. Front-to-back rotation is not possible.
- Thread size
- Lug bolt or nut thread — needed when buying aftermarket fasteners.
Considering a different size?
Run your OE size against the one you want to see diameter change, ground clearance and speedometer error.
Recent articles
