1983 Toyota Hilux tire and wheel sizes, bolt pattern and tire pressure
Check the tables below for every tire size, wheel size, bolt pattern (PCD), rim offset and tire pressure fitted to the 1983 Toyota Hilux.
Fitment tables
8 trims sold in 1983
Open a trim for its factory package and every alternative size, front and rear. More than one generation was on sale this year — check the chassis code against your VIN before ordering.
Toyota Hilux III
1978 – 1983 2 trims
Hilux 2.2 4WD
63 hp · I4
235/75 R15 1 fitment
GenerationIII 1978–1983
MarketEurope
Power63 hp
EngineI4, Diesel
Center bore106.1 mm
PCD6x139.7
ThreadM12 x 1.5
| Tire size | Rim size and bolt pattern | Pressure, psi | Prices |
|---|---|---|---|
| 235/75 R15 | | – | Tires |
Hilux 2.2 D 2WD
63 hp · I4
185x R14 89S 3 fitments
No trims match these filters
Try a trim name or an engine size like 2.0L.
Reading the table
What these columns mean
- OE fitment
- The package fitted at the factory for that trim.
- Alternative
- A size the car accepts without modification — plus-sizing, winter setups or optional wheels.
- Rim size
- Rim diameter × width in inches, and the factory offset (ET) in millimetres, e.g. 18x7.5 ET25.
- Bolt pattern (PCD)
- Number of studs and the diameter of the circle they sit on. It must match exactly.
- Center bore
- Diameter of the hub hole. Larger aftermarket bores need hub-centric rings.
- Pressure
- Recommended cold inflation pressure for that axle, in psi.
- Staggered
- A wider tire on the rear axle than the front. Front-to-back rotation is not possible.
- Thread size
- Lug bolt or nut thread — needed when buying aftermarket fasteners.
Considering a different size?
Run your OE size against the one you want to see diameter change, ground clearance and speedometer error.
Recent articles
