2009 GAC Honda Accord tire and wheel sizes, bolt pattern and tire pressure

Check the tables below for every tire size, wheel size, bolt pattern (PCD), rim offset and tire pressure fitted to the 2009 GAC Honda Accord.

2009 GAC Honda Accord tire sizes

Bolt pattern

Other years

Fitment tables

Open a trim for its factory package and every alternative size, front and rear.

2008 – 2010 China market 3 trims

154 hp · R20A I4 215/60 R16 94H 2 fitments

GenerationVIII CP 2008–2010

Power154 hp

EngineR20A I4, Petrol

Center bore64.1 mm

PCD5x114.3

ThreadM12 x 1.5

Tire size	Rim size and bolt pattern	Pressure, psi	Prices
215/60 R16 94H	16x6.5 ET50 ~~5x114.3~~	30	Tires Rims
225/50 R17 93V	17x7.5 ET55 ~~5x114.3~~	32	Tires Rims

177 hp · K24Z I4 215/60 R16 94H 2 fitments

GenerationVIII CP 2008–2010

Power177 hp

EngineK24Z I4, Petrol

Center bore64.1 mm

PCD5x114.3

ThreadM12 x 1.5

Tire size	Rim size and bolt pattern	Pressure, psi	Prices
215/60 R16 94H	16x6.5 ET50 ~~5x114.3~~	30	Tires Rims
225/50 R17 93V	17x7.5 ET55 ~~5x114.3~~	32	Tires Rims

276 hp · J35Z V6 225/50 R17 93V 2 fitments

GenerationVIII CP 2008–2010

Power276 hp

EngineJ35Z V6, Petrol

Center bore64.1 mm

PCD5x114.3

ThreadM12 x 1.5

Tire size	Rim size and bolt pattern	Pressure, psi	Prices
225/50 R17 93V	17x7.5 ET55 ~~5x114.3~~	32	Tires Rims
235/45 R18 94V	18x8 ET55 ~~5x114.3~~	33	Tires Rims

Reading the table

OE fitment: The package fitted at the factory for that trim.
Alternative: A size the car accepts without modification — plus-sizing, winter setups or optional wheels.
Rim size: Rim diameter × width in inches, and the factory offset (ET) in millimetres, e.g. 18x7.5 ET25.
Bolt pattern (PCD): Number of studs and the diameter of the circle they sit on. It must match exactly.
Center bore: Diameter of the hub hole. Larger aftermarket bores need hub-centric rings.
Pressure: Recommended cold inflation pressure for that axle, in psi.
Staggered: A wider tire on the rear axle than the front. Front-to-back rotation is not possible.
Thread size: Lug bolt or nut thread — needed when buying aftermarket fasteners.